These same steps work for programming to an external receiver or a gate opener with a learn button. If the garage door does not open and close, repeat the programming steps. Press the button you just programmed to verify the garage door opener remote is programmed and the garage door opens and closes using the remote. Press and release the program button to exit the programming mode. Continue to press the button until you hear a click from the garage door opener, the light on the garage door opener flashes or the garage door starts to open.ĥ. Wait until the LED on the remote stops flashing between button pushes. Press and release the button on the remote you want to operate the garage door opener. Always use caution any time you use a ladder to prevent accidental falls. You will have to use a ladder to locate and access the learn button. The learn button will be on the back or side of the garage door opener motor.

Press the learn button on the garage door opener or external receiver. Press and hold the program button for about 2 seconds, until the LED light illuminates.ģ. Inside the remote you will see a program button on one side and DIP switches on the other side. Open the remote by sliding the battery cover open. Programming the clicker universal remote to a garage door opener/receiver with learn button: 1. Newer garage door openers utilize a learn button and older units utilize DIP switches. The first step is determining if your garage door opener or external receiver uses a learn button or DIP switches. The Chamberlain Clicker Universal Remote Control (KLIK1U, KLIK3U, KLIK3U-BL, KLIK3U-PK) aka LiftMaster 375UT (375 LM) is a universal remote that will program to most garage door openers and external receivers using learn buttons or DIP switches.

Programing chamberlain keypad